The sawing quality of the TCT circular saw blade has a lot to do with factors such as whether the feeder drum rotates synchronously, whether the felt is in good condition and clean, and whether the residual garbage on the surface of the profile is cleaned up, etc. The details are as follows: :
1. Before starting the machine, check whether the rollers of the feeding rack rotate synchronously and whether the protective felt is in good condition and clean.
2. Check whether the machine table is clean, check whether the material rack or material rack is in good condition and whether the screws on the bottom and both sides of the material rack are loose.
3. Lift the material to the material rack, the height of the material rack is more than 10cm higher than the material rack, and then put it into the material rack to avoid the collision between the profile and the material rack. Also, handle with care.
4. When sawing, multiple saws will clean up the garbage on the machine table, and then cut the next batch of materials. Many saws mainly focus on the pressing device to ensure the stability of pressing and sewing. Many saws have corresponding requirements for the number of teeth and angles of TCT circular saw blades, which are different from single saws.
5. During the framing process, the profiles should keep a certain distance from both sides of the material frame. There should be a certain gap between the profiles or separated from each other with high temperature felt. Avoid rubbing flowers and bumping. After sawing, the profiles must be placed neatly, with no burrs at both ends, no deformation of the saw edge, and no oil stains; the aluminum scraps on the surface of the profiles should be blown clean to prevent the aluminum scraps from scratching the profiles again.
6. When mounting profiles, the principle of long material below, short material above, thick material below, and thin material above must be followed.